Drive Belt: Service and Repair
DRIVE BELTDrive Belt Components:
REMOVAL
1. REMOVE ENGINE UNDER COVER RH
2. REMOVE NO. 1 AIR CLEANER INLET
a. Loosen the clamp, and disconnect the air cleaner inlet from the air cleaner case.
3. REMOVE DRIVE BELT
a. Loosen nut A.
b. Turn adjust bolt B, and then release the belt tension.
c. Remove the belt.
INSTALLATION
1. INSTALL DRIVE BELT
a. Temporarily install the belt on each pulley.
2. ADJUST DRIVE BELT TENSION
a. Turn adjust bolt B to adjust the belt tension.
b. Tighten nut A.
Torque: 40 Nm (408 kgf-cm, 30 ft. lbs.)
3. CHECK DRIVE BELT TENSION
4. CONNECT NO. 1 AIR CLEANER INLET
a. Connect the air cleaner inlet to the air cleaner case and tighten the clamp.
Torque: 3.0 Nm (31 kgf-cm, 27 inch lbs.)
5. INSTALL ENGINE UNDER COVER RH