Overhaul
DISASSEMBLY1. REMOVE COOLER DRYER
a. Using a 14 mm hexagon wrench, remove the cap from the modulator.
b. Remove the O-ring from the cap.
c. Using pliers, remove the cooler dryer.
REASSEMBLY
1. INSTALL COOLER DRYER
a. Using pliers, install the cooler dryer to the modulator.
b. Install a new O-ring to the cap.
c. Sufficiently apply compressor oil (ND-OIL 11) to the O-ring and cap fitting surface.
Compressor oil: ND-OIL 11 or equivalent
NOTE:
- Do not use any compressor oil other than ND-OIL 11.
- If any compressor oil other than ND-OIL 11 is used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.
d. Using a 14 mm hexagon wrench, install the cap to the modulator.
Torque: 2.9 N.m (30 kgf.cm, 25 in.lbf)