Steering Mounted Controls Transmitter: Service and Repair

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

2. REMOVE LOWER NO. 3 STEERING WHEEL COVER
3. REMOVE LOWER NO. 2 STEERING WHEEL COVER
4. REMOVE STEERING PAD
5. REMOVE STEERING PAD SWITCH LH (for 4 Spoke)




a. Disconnect the pad switch connector from the spiral cable.
b. Remove the screw.
c. Disengage the 2 pins and remove the steering pad switch LH.

6. REMOVE STEERING PAD SWITCH ASSEMBLY (for 4 Spoke)




a. Disconnect the pad switch connector from the spiral cable.
b. Remove the screw.
c. Disengage the 2 pins and remove the steering pad switch.




d. Remove the screw.
e. Disengage the 2 pins and remove the steering pad switch assembly.

7. REMOVE STEERING PAD SWITCH LH (for 3 Spoke)




a. Disconnect the pad switch connector from the spiral cable and disengage the clamp.
b. Remove the screw.
c. Disengage the 2 pins and remove the steering pad switch LH.

8. REMOVE STEERING PAD SWITCH ASSEMBLY (for 3 Spoke)




a. Disconnect the pad switch connector from the spiral cable.
b. Disengage the clamp and remove the screw.
c. Disengage the 2 pins and remove the steering pad switch.




d. Disengage the clamp and remove the screw.
e. Disengage the 2 pins and remove the steering pad switch assembly.

INSTALLATION

1. INSTALL STEERING PAD SWITCH ASSEMBLY (for 4 Spoke)




a. Engage the 2 pins and install the steering pad switch assembly.
b. Install the screw.

Torque: 2.4 N.m (24 kgf.cm, 21 in.lbf)




c. Engage the 2 pins and install the steering pad switch assembly.
d. Install the screw.

Torque: 2.4 N.m (24 kgf.cm, 21 in.lbf)

e. Connect the connector to the spiral cable.

2. INSTALL STEERING PAD SWITCH LH (for 4 Spoke)




a. Engage the 2 pins and install the steering pad switch LH.
b. Install the screw.

Torque: 2.4 N.m (24 kgf.cm, 21 in.lbf)

c. Connect the connector to the spiral cable.

3. INSTALL STEERING PAD SWITCH ASSEMBLY (for 3 Spoke)




a. Engage the 2 pins and install the steering pad switch assembly.
b. Install the screw and engage the clamp.

Torque: 2.4 N.m (24 kgf.cm, 21 in.lbf)




c. Engage the 2 pins and install the steering pad switch assembly.
d. Install the screw and engage the clamp.

Torque: 2.4 N.m (24 kgf.cm, 21 in.lbf)

e. Connect the connector to the spiral cable.

4. INSTALL STEERING PAD SWITCH LH (for 3 Spoke)




a. Engage the 2 pins and install the steering pad switch LH.
b. Install the screw and engage the clamp.

Torque: 2.4 N.m (24 kgf.cm, 21 in.lbf)

c. Connect the connector to the spiral cable.

5. INSTALL STEERING PAD
6. INSTALL LOWER NO. 3 STEERING WHEEL COVER
7. INSTALL LOWER NO. 2 STEERING WHEEL COVER
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. INSPECT SRS WARNING LIGHT