Removal and Replacement
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE AIR CLEANER INLET ASSEMBLY
3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
5. REMOVE STARTER ASSEMBLY (for Manual Transaxle)
a. Disconnect the terminal 50 connector from the starter assembly.
b. Remove the nut and disconnect the wire harness from terminal 30.
c. Remove the 3 bolts, clutch flexible hose bracket and starter assembly.
6. REMOVE STARTER ASSEMBLY (for Automatic Transaxle)
a. Disconnect the terminal 50 connector from the starter assembly.
b. Remove the nut and disconnect the wire harness from terminal 30.
c. Remove the 2 bolts and starter assembly.
INSTALLATION
1. INSTALL STARTER ASSEMBLY (for Manual Transaxle)
a. Install the starter assembly and clutch flexible hose bracket with the 3 bolts.
Torque:
Bolt A
37 N.m (380 kgf.cm, 28 ft.lbf)
Bolt B
12 N.m (120 kgf.cm, 9 ft.lbf)
b. Connect the wire harness to terminal 30 and install the nut. Then, attach the terminal cap.
Torque: 9.8 N.m (100 kgf.cm, 87 in.lbf)
c. Connect the terminal 50 connector to the starter assembly.
2. INSTALL STARTER ASSEMBLY (for Automatic Transaxle)
a. Install the starter assembly with the 2 bolts.
Torque: 37 N.m (380 kgf.cm, 28 ft.lbf)
b. Connect the wire harness to terminal 30 and install the nut. Then, attach the terminal cap.
Torque: 9.8 N.m (100 kgf.cm, 87 in.lbf)
c. Connect the terminal 50 connector to the starter assembly.
3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
5. INSTALL AIR CLEANER INLET ASSEMBLY
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL