Accessory Control Display: Service and Repair

Multi-Display:

Multi-Display:

MULTI-DISPLAY

REMOVAL

1. TABLE OF BOLT, SCREW AND NUT

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE STEERING WHEEL COVER LOWER NO. 2
4. REMOVE STEERING WHEEL COVER LOWER NO. 3
5. REMOVE STEERING PAD
6. REMOVE STEERING WHEEL ASSEMBLY
7. REMOVE STEERING COLUMN COVER
8. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE
9. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 1
10. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 2
11. REMOVE INSTRUMENT PANEL FINISH PLATE
12. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
13. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER
14. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
15. REMOVE ACCESSORY METER ASSEMBLY

16. REMOVE MULTI DISPLAY




a. Disengage the 9 claws and remove the back cover.




b. Remove the 4 screws and multi display.

INSTALLATION

1. INSTALL MULTI DISPLAY
2. INSTALL ACCESSORY METER ASSEMBLY
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER
5. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
6. INSTALL INSTRUMENT PANEL FINISH PLATE
7. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 2
8. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 1
9. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE
10. INSTALL STEERING COLUMN COVER
11. ADJUST SPIRAL CABLE
12. INSTALL STEERING WHEEL ASSEMBLY
13. INSTALL STEERING PAD
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
15. PERFORM SYSTEM INITIALIZE
16. INSPECT STEERING PAD
17. INSPECT SRS WARNING LIGHT