Removal and Installation

Starter (Part 1):

REMOVAL

1. REMOVE BATTERY AND TRAY

2. w/ CRUISE CONTROL SYSTEM:
REMOVE CRUISE CONTROL ACTUATOR
a. Disconnect the actuator connector and clamp.
b. Remove the 3 bolts, and disconnect the actuator with the bracket.

3. REMOVE STARTER
a. Disconnect the starter connector
b. Remove the 2 bolts, throttle cable clamp (A/T) and starter.
c. Remove the nut, and disconnect the starter wire.
Torque: 37 N.m (380 kgf.cm, 27 ft.lbf)

INSTALLATION
Installation Is In the reverse order of removal.