Ignition Lock: Service and Repair

Fig. 3 Ignition Lock Removal:

1. On models with audio coded anti-theft system, disable system as outlined under Technician Safety Information.
2. On models with airbag, disable airbag system as described under Technician Safety Information. On models less airbag, disconnect battery ground cable.
3. Turn ignition switch to ACC position.
4. Insert a small diameter rod into hole located on side of lock cylinder, then while holding down pin, remove lock cylinder, Fig. 3.
5. Reverse procedure to install. Ensure lock cylinder is in ACC position. Arm airbag system as previously described. If audio system was disabled, activate as outlined under Technician Safety Information.