Federal Spec. Vehicles

REMOVAL PROCEDURE
1. REMOVE DISTRIBUTOR CAP WITHOUT DISCONNECTING HIGH-TENSION CORDS.
2. REMOVE ROTOR.
3. REMOVE IGNITION COIL DUST COVER.
4. REMOVE IGNITION COIL.



- Remove the 2 nuts, and disconnect the 3 wires from the ignition coil terminals.



- Remove the 4 screws and ignition coil.


INSTALLATION PROCEDURE
1. INSTALL IGNITION COIL



- Remove any old packing (FIPG) material.
- Apply seal packing to the ignition coil installing surface of the housing as shown in the illustration.
Seal packing: Part No.08826-00080 or equivalent




- Install the ignition coil with the 4 screws.



- Connect the 3 wires to the ignition coil terminals with the 2 nuts.




NOTICE: When connecting the wires to the ignition coil, insert both properly into their grooves found on the side of the Ignition coil. Be sure the wires do not contact with signal rotor or distributor housing.

2. INSTALL IGNITION COIL DUST COVER.
3. INSTALL ROTOR.
4. INSTALL DISTRIBUTOR CAP AND HIGH-TENSION CORDS.
5. RECONNECT DISTRIBUTOR CONNECTORS.