Deceleration Sensor Operation/Check

5. (4WD vehicles) INSPECT DECELERATION SENSOR SIGNAL

(a) Drive the vehicle straight ahead at about 20 km/h (12.4 mph) or more, depress the brake pedal a little strong.






(b) Check that the warning light turns on while braking.

(c) Stop the vehicle.

6. READ DIAGNOSTIC TROUBLE CODE






(a) Using SST, connect the terminals Tc to E1 of the data link connector 1. SST 09843-18020

HINT: Do not disconnect the terminal Ts to E1.






(b) Read the number of blinks.
(See DIAGNOSTIC TROUBLE CODE)

HINT: The first number of blinks will equal the first digit of a two digit diagnostic trouble code. After a 1.5 second pause, the 2nd number of blinks will equal the 2nd number of a two digit code. If there are two or more codes, there will be a 2.5 second pause between each code, and then indication will begin again after a 4.0 second pause, continuing in order from the smaller value up to the larger one.

Diagnostic Trouble Code Descriptions:

DIAGNOSTIC CODE