Installation

EXTERIOR: FENDER LINER (for Front Side):

INSTALLATION

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH





(a) for Steel Type Bumper:
Install the front fender splash shield.
(1) Install the fender splash shield with the 2 screws, clip and 2 new clips labeled A.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)





(b) for Resin Type Bumper:
Install the front fender splash shield.
(1) Install the fender splash shield with the 2 screws and 2 clips.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
(2) Install the pin hold clip so that its groove is vertical.
2. INSTALL FENDER APRON MUDGUARD SEAL LH
(a) for Steel Type Bumper:
Install the fender apron mudguard seal.
(1) Install the fender apron mudguard with the 3 clips and 15 new clips labeled A.





(2) w/ Front Fender Mudguard:
Install the front fender mudguard (Installation).
(3) w/ Side Step:
Install the side step (Installation).
(b) for Resin Type Bumper:
Install the fender apron mudguard seal.
(1) Install the fender apron mudguard with the 2 clips and 15 new clips labeled A.
(2) Install the pin hold clip so that its groove is vertical.





(3) w/ Front Fender Mudguard:
Install the front fender mudguard (Installation).
(4) w/ Side Step:
Install the side step (Installation).