Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION

INSTALLATION





1. INSTALL REAR SPEED SENSOR LH
(a) Using a hexagon wrench, install the rear speed sensor with the bolt.
Torque: 8.3 Nm (85 kgf-cm, 73 in-lbf)
NOTICE:
- Make sure that there are no pieces of iron or other foreign matter attached to the sensor tip part.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip part.
- After installing the speed sensor, make sure that there is no clearance or foreign matter between the sensor stay part and the knuckle.
- Make sure that there is no foreign matter attached to the magnetic rotor.

(b) Connect the rear speed sensor connector.
2. INSTALL REAR WHEEL Installation

3. INSPECT SPEED SENSOR SIGNAL
Test Mode Procedure