Data List / Active Test

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: DATA LIST / ACTIVE TEST

DATA LIST / ACTIVE TEST

1. READ DATA LIST
HINT: Using Techstream's Data List allows switch, sensor, actuator and other item values to be read without out removing any parts. Reading the Data List early in troubleshooting is one way to save time.

(a) Connect Techstream to the DLC3.
(b) Turn the ignition switch ON.
(c) Turn Techstream on.
(d) Read the Data List according to the display on the tester.

ABS / VSC / TRAC:





















HINT:
- *1: SFRH (S: Solenoid, F: Front, R: Right, H: Holding)
- *2: SFRR (S: Solenoid, F: Front, R: Right, R: Reduction)
- *3: SFLH (S: Solenoid, F: Front, L: Left, H: Holding)
- *4: SFLR (S: Solenoid, F: Front, L: Left, R: Reduction)
- *5: SRRH (S: Solenoid, R: Rear, R: Right, H: Holding)
- *6: SRRR (S: Solenoid, R: Rear, R: Right, R: Reduction)
- *7: SRLH (S: Solenoid, R: Rear, L: Left, H: Holding)
- *8: SRLR (S: Solenoid, R: Rear, L: Left, R: Reduction)
- *9: w/ Downhill assist control
- *10: for 2WD (w/ AUTO LSD)

2. PERFORM ACTIVE TEST
HINT: Performing Techstream's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

(a) Connect Techstream to the DLC3.
(b) Turn the ignition switch ON.
(c) Turn Techstream on.
(d) Perform the Active Test according to the display on the tester.
HINT:
- The ignition switch must be turned ON to proceed to the Active Test using Techstream.
- The Active Tests of the ABS solenoid, ABS motor relay, ABS warning light and BRAKE warning light are available when the vehicle is stopped.
- The motors stop automatically after 5 seconds of activation to prevent them from being damaged. When the motors are driven repeatedly, certain intervals are required.
- Each solenoid stops automatically after 2 seconds of activation to prevent them from being damaged, and can be operated again after a certain interval.
- Do not depress the brake pedal while only the pressure reduction solenoid valves are on.
- Do not drive 2 or more solenoids simultaneously except to operate the pressure holding solenoid valves and pressure reduction solenoid valves of each wheel.

ABS / VSC / TRAC:





HINT: *1: w/ Downhill assist control
*2: for 2WD (w/ AUTO LSD)