Replacement
GENERATOR ASSEMBLYREPLACEMENT
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE V-BANK COVER
3. REMOVE RADIATOR SUPPORT TO FRAME SEAL LH
4. REMOVE FAN SHROUD
5. REMOVE GENERATOR ASSEMBLY
a. Disconnect the wire harness.
1. Remove the bolt and wire harness stay.
2. Disconnect the connector from the generator assembly.
3. Remove the terminal cap and nut.
4. Disconnect the wire harness from terminal B.
b. Remove the 2 bolts, then separate the wire harness clamp bracket from the generator assembly.
c. Remove the 2 bolts, then remove the generator assembly.
6. INSTALL GENERATOR ASSEMBLY
a. Install the generator assembly with the 2 bolts.
Torque: 43 N.m (438 kgf.cm, 32 ft.lbf)
b. Install the wire harness clamp bracket with the 2 bolts.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
c. Connect the wire harness.
1. Connect the wire harness to terminal B and install the nut.
Torque: 9.8 N.m (100 kgf.cm, 7.0 ft.lbf)
2. Connect the connector to the generator assembly.
3. Install the wire harness stay with the bolt.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
7. INSTALL FAN SHROUD
8. INSTALL RADIATOR SUPPORT TO FRAME SEAL LH
9. INSTALL V-BANK COVER
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)