Blower Motor Resistor: Service and Repair
BLOWER MOTOR LINEAR CONTROLLERINSPECTION
1. REMOVE GLOVE COMPARTMENT PARTS
2. REMOVE LOWER NO. 2 FINISH PANEL
3. REMOVE LOWER CENTER COVER
4. REMOVE LOWER LH FINISH PANEL
5. REMOVE NO. 4 HEATER TO REGISTER DUCT
6. REMOVE BLOWER MOTOR LINEAR CONTROLLER
a. Disconnect the connector.
b. Remove the 2 screws and blower motor linear controller.
7. INSPECT BLOWER MOTOR LINEAR CONTROLLER
Refer to Heating and Air Conditioning; Testing and Inspection.
8. INSTALL BLOWER MOTOR LINEAR CONTROLLER
a. Install the blower motor linear controller with the 2 screws.
b. Connect the connector.
9. INSTALL NO. 4 HEATER TO REGISTER DUCT
10. INSTALL LOWER LH FINISH PANEL
11. INSTALL LOWER CENTER COVER
12. INSTALL LOWER NO. 2 FINISH PANEL
13. INSTALL GLOVE COMPARTMENT PARTS