Front Seat

REMOVAL

CAUTION:
- Wear safety gloves, because the cutting surface of the seatback frame and seat adjuster may injure your hand.
- Work must be started at least 90 seconds after the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.
(The SRS is equipped with a back-up power source. If work is started within 90 seconds after disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)

HINT: A bolt without a torque specification is shown in the standard bolt chart.

REMOVE FRONT SEAT
Remove the 4 bolts and front seat.

NOTE: Be careful not to damage the body.

INSTALLATION

INSTALL FRONT SEAT
a. Slide the front seat to the frontmost position.

NOTE: Make sure that seat adjuster locks.

b. Without holding the seat track adjusting handle, mount the seat to the vehicle.

HINT: If holding the seat track adjusting handle, the adjusted frontmost position will slip off.

c. Tighten the bolts on the rear side temporarily, tighten them completely starting from the bolt on the inner side.

Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)

d. Slide the seat to the rearmost position to install the bolts on the front side.

Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)