Windshield Wiper Motor Assy
WINDSHIELD WIPER MOTOR ASSEMBLYREPLACEMENT
HINT: Installation is in the reverse order of removal.
1. REMOVE WINDSHIELD WIPER ARM COVER
2. REMOVE FR WIPER ARM & BLADE ASSEMBLY LH
a. Stop the windshield wiper motor assembly at the automatic stop position.
b. Remove the nut and the FR wiper arm & blade assembly LH.
3. REMOVE FR WIPER ARM & BLADE ASSEMBLY RH
a. Remove the nut and the FR wiper arm & blade assembly RH.
4. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
a. Disengage the 6 claws.
b. Remove the 2 clips.
c. Disengage the 9 claws, and remove the cowl top ventilator louver sub-assembly.
5. REMOVE WINDSHIELD WIPER MOTOR & LINK ASSEMBLY
a. Disconnect the connector.
b. Remove the 2 bolts.
c. Remove the windshield wiper motor & link assembly by disengaging the pin as shown in the illustration.
6. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
a. Using a screwdriver, disengage the meshing of the 2 rods at the crank arm pivot of the windshield wiper motor assembly.
b. Using a torx(R) socket wrench, remove the 2 bolts and the windshield wiper motor assembly.
7. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
a. Apply MP grease to the clank arm pivot of the windshield wiper motor assembly.
b. Using a torx(R) socket wrench, install the windshield wiper motor assembly with the 2 bolts.
Torque: 5.39 N.m (55 kgf.cm, 48 in.lbf)
8. INSTALL WINDSHIELD WIPER MOTOR & LINK ASSEMBLY
a. Temporarily install the windshield wiper & Link assembly by engaging the pin.
b. Install the windshield wiper motor & link assembly with the 2 bolts.
Torque: 7.0 N.m (71 kgf.cm, 61 in.lbf)
c. Connect the connector.
9. INSTALL FR WIPER ARM & BLADE ASSEMBLY RH
a. Stop the windshield wiper motor assembly at the automatic stop position.
b. Scrape off the serration part of the wiper arm with a round file or equivalent.
c. Clean the wiper pivot serration with a wire brush.
d. Install the front wiper arm & blade assembly RH with the nut to the position shown in the illustration.
Torque: 24 N.m (245 kgf.cm, 18 ft.lbf)
HINT: Hold down the arm hinge by hand in order to fasten the nut.
10. INSTALL FR WIPER ARM & BLADE ASSEMBLY LH
a. Scrape off the serration part of the wiper arm with a round file or equivalent.
b. Clean the wiper pivot serration with a wire brush.
c. Install the front wiper arm & blade assembly LH with the 2 nuts to the position shown in the illustration.
Torque: 24 N.m (245 kgf.cm, 18 ft.lbf)
HINT: Hold down the arm hinge by hand in order to fasten the nut.
d. Operate the wiper while running water or washer fluid over the window, and check the wiping condition and that the front wiper does not scrape against the body.