Shift Cable: Service and Repair

TRANSMISSION CONTROL CABLE ASSEMBLY (ATM)
REPLACEMENT
1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER
2. REMOVE FLOOR CARPET COVER CENTER RH
3. REMOVE FLOOR CARPET COVER CENTER LH
4. REMOVE BATTERY
5. REMOVE AIR CLEANER ASSEMBLY
6. REMOVE AIR CLEANER HOSE NO.1
7. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY





a. Remove the nut from the control shaft lever.
b. Disconnect the control cable from the control shaft lever.





c. Remove the clip and disconnect the control cable from the control cable bracket.





d. Disconnect the control cable from the control cable clamp.





e. Disconnect the cable end from the rod of the floor shift assembly.





f. Remove the 2 nuts.





g. Remove the 3 bolts.
h. Pull out the control cable from the body.
8. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY





a. Pull in the control cable to the body.
b. Install the 3 bolts.
Torque: 4.9 Nm (50 kgf-cm, 43 inch lbs.)





c. Install the cable end, as shown in the illustration.

HINT: Install it with the uneven surface facing up.





d. Install the control cable and 2 nuts.
Torque: 11.8 Nm (122 kgf-cm, 9 ft. lbs.)





e. Connect the control cable to the control cable clamp.





f. Temporarily install the control cable to the control shaft lever with nuts.





g. Install the control cable and clip to the bracket.
9. INSTALL AIR CLEANER ASSEMBLY
10. ADJUST SHIFT LEVER POSITION
11. INSPECT SHIFT LEVER POSITION