Refrigerant Pressure Sensor / Switch: Service and Repair

REMOVAL
1. REMOVE EVAPORATOR

2. REMOVE PRESSURE SWITCH FROM LIQUID TUBE
Disconnect the connector and remove the pressure switch.
Torque: 10 N.m (100 kgf.cm, 7 ft.lbf)

HINT:
^ Lock the switch mounted on the tube with an open end wrench, being careful not to deform the tube and remove the switch.
^ At the time of installation, please refer to the following item.
Lubricate a new O-ring with the compressor oil and install the switch.

INSTALLATION
Installation is in the reverse order of removal