Removal and Installation

REMOVAL
1. Remove front wheel.
Remove the wheel and temporarily fasten the disc with the hub nuts.





2. Disconnect flexible hose.
a. Remove the union bolt and 2 gaskets from the caliper, then disconnect the flexible hose from the caliper.
Torque: 29 Nm (21 ft. lbs.)

HINT: At the time of installation, please refer to the following item.
Install the flexible hose lock securely in the lock hole in the caliper.

b. Use a container to catch the brake fluid as it drains out.

3. Remove caliper.
a. Hold the sliding pin and loosen the 2 installation bolts, and remove the installation bolts.
Torque: 34 Nm (25 ft. lbs.)
b. Remove the caliper from the torque plate.

4. Remove these parts:
a. 2 anti-squeal springs.
b. 2 brake pads with 4 anti-squeal shims.
c. 4 pad support plates.

INSTALLATION
Installation is in the reverse order of removal. After installation, fill brake reservoir with brake fluid, bleed brake system and check for leaks.