Receiver Dryer: Service and Repair

REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM

HINT: At the time of installation, please refer to the following item.
Evacuate air from refrigeration system.
Charge system with refrigerant and inspect for leakage of refrigerant.
Specified amount: 700 ± 50 g (24.69 ± 1.76 oz.)

2. REMOVE THESE PARTS:
a. Coolant reservoir
b. Air cleaner case




3. DISCONNECT 2 LIQUID TUBES
Remove the 2 bolts and disconnect the both tubes.
Torque: 10 N.m (100 kgf.cm, 7 ft.lbf)

NOTE: Cap the open fittings immediately to keep moisture or dirt out of the system.

HINT: At the time of installation, please refer to the following item.
Lubricate 2 new O-rings with compressor oil and install the tube.

4. REMOVE RECEIVER
Remove the holder bolt and pull out the receiver.

HINT: At the time of installation, please refer to the following item.
If receiver is replaced add compressor oil to receiver.
Add 10 cc (0.34 fl.oz.)
Compressor oil: ND-OIL 8 or equivalent.

INSTALLATION
Installation is in the reverse order of removal.