Load Compensator: Service and Repair

REMOVAL
1. Disconnect brake lines.





Using Special Service Tool (SST) 09023-00100 or equivalent, disconnect the brake lines from the valve body.
2. Remove Load Sensing Proportioning & By-Pass Valve (LSP & BV) assembly.





a. Remove the lock nut and disconnect the adjusting bolt from the rear suspension arm.





NOTICE: At the time of installation, please refer to the following item.
Set spring length A to initial set length and temporarily tighten the lock nut.
Initial set length (Unladen): 222.5 mm (8.760 inch)





b. Remove the 2 mounting bolts and LSP & BV assembly.
Torque: 29 Nm (22 ft. lbs.)
c. Remove the 2 nuts and Load Sensing LSP & BV from the bracket.
Torque: 13 Nm (9 ft. lbs.)

INSTALLATION
Installation is in the reverse order of removal. After installation, fill brake reservoir with brake fluid, bleed brake system, check and adjust fluid pressure and check for leaks.