Compressor Clutch: Service and Repair

MAGNETIC CLUTCH DISASSEMBLY







1. REMOVE PRESSURE PLATE







a. Using SST and socket wrench. remove the shaft bolt.
SST 07112-76060

Torque: 13.2 N.m (135 kgf.cm, 9 ft.lbf)







b. Install a SST on the pressure plate.
SST 07112-66040







c. Using SST and socket wrench, remove the pressure plate.
SST 07112-76060







d. Remove the shims from the pressure plate.

2. REMOVE ROTOR







a. Using SST, remove the snap ring.
SST 07114-84020







ASSEMBLY NOTE: The snap ring should be installed so that its beveled side face up.







b. Using a plastic hammer, tap the rotor off the shaft.

DISASSEMBLY NOTE: Be careful not to damage the pulley when tapping on the rotor.


3. REMOVE STATOR







a. Disconnect the stator lead wire from the compressor housing.







b. Using SST, remove the snap ring.
SST 07114-84020







ASSEMBLY NOTE: The snap ring should be installed so that its beveled side face up.







c. Remove the stator.




MAGNETIC CLUTCH ASSEMBLY
Assembly is in the reverse order of disassembly.

CHECK CLEARANCE OF MAGNETIC CLUTCH
Clearance Check