Power Steering Pump

SERVICE SPECIFICATIONS
Oil Clearance Between Pump Shaft And Bushing:
Standard 0.03 - 0.05 mm (0.0012 - 0.0020 inch)
Maximum 0.07 mm (0.0028 inch)
Vane Plate (Minimum):
Height 8.1 mm (0.319 inch)
Thickness 1.797 mm (0.07075 inch)
Length 14.988 mm (0.59008 inch)
Clearance Between Rotor Groove And Vane Plate:
Maximum 0.03 mm (0.0012 inch)
Vane Length:
Pump Rotor And Cam Ring Mark:
NONE 14.998 - 14.998 mm (0.59039 - 0.59047 inch)
1 14.994 - 14.996 mm (0.59031 - 0.59039 inch)
2 14.992 - 14.994 mm (0.59024 - 0.59031 inch)
3 14.990 - 14.992 mm (0.59016 - 0.59024 inch)
4 14.988 - 14.990 mm (0.59008 - 0.59016 inch)
Spring Free Length:
Minimum 36 mm (1.42 inch)
Vane Pump Rotating Torque:
Maximum 0.3 Nm (2.4 inch lbs.)

TIGHTENING SPECIFICATIONS
Pressure Feed Tube To Control Valve Housing:
With Special Service Tool (SST) 36 Nm (26 ft. lbs.)
Without SST 44 Nm (32 ft. lbs.)
PS Vane Pump Assembly Set Bolt 43 Nm (32 ft. lbs.)
Bracket Set Bolt 43 Nm (32 ft. lbs.)
Union Bolt To Pressure Feed Tube 51 Nm (38 ft. lbs.)
Vane Pump Pulley Set Nut 43 Nm (32 ft. lbs.)
Air Control Valve 36 Nm (27 ft. lbs.)
Union Bolt To Pressure Feed No. 2 Tube 69 Nm (51 ft. lbs.)
Suction Port Union Set Bolt 13 Nm (9 ft. lbs.)
Pressure Port Union 69 Nm (51 ft. lbs.)
Front Exhaust Pipe To
Exhaust Center Pipe 48 Nm (35 ft. lbs.)
Exhaust Manifold 62 Nm (46 ft. lbs.)
Tube Clamp Set Bolt 13 Nm (9 ft. lbs.)
Lower Suspension Arm Bracket To Body 137 Nm (101 ft. lbs.)
Suspension Crossmember To
Body 206 Nm (152 ft. lbs.)
Suspension Centermember 112 Nm (82 ft. lbs.)
Clamp 8.3 Nm (73 inch Lbs.)
Power Steering Gear Assembly 113 Nm (83 ft. lbs.)
Lower Ball Joint To Lower Suspension Arm 127 Nm (94 ft. lbs.)
Stabilizer Bar With Link To Lower Suspension Arm:
All Over Fender Vehicle 74 Nm (54 ft. lbs.)
2 Door Vehicle 44 Nm (33 ft. lbs.)
4 Door Vehicle 74 Nm (54 ft. lbs.)
Stabilizer Bar Bracket To Suspension Crossmember 29 Nm (22 ft. lbs.)