Steering Column

SERVICE SPECIFICATIONS
Tilt Pawl Stopper (Mark):
1 or A 12.65 - 12.75 mm (0.4980 - 0.5020 inch)
2 or B 12.55 - 12.65 mm (0.4941 - 0.4980 inch)
3 or C 12.45 - 12.55 mm (0.4902 - 0.4941 inch)
4 or D 12.35 - 12.45 mm (0.4862 - 0.4902 inch)
5 or E 12.25 - 12.35 mm (0.4823 - 0.4862 inch)

TIGHTENING SPECIFICATIONS
Turn Signal Bracket Set Bolt 7.8 Nm (69 inch lbs.)
Tilt Lever Assembly Set Bolt 2.9 Nm (26 inch lbs.)
Tilt Sub Lever Side Pawl Set Bolt To Nut 5.9 Nm (52 inch lbs.)
Tilt Lever Retainer Set Bolt 15 Nm (11 ft. lbs.)
Compression Spring Set Bolt 7.8 Nm (69 inch lbs.)
Intermediate Shaft To Main Shaft 35 Nm (26 ft. lbs.)
Column Lower Tube To Column Tube 19 Nm (14 ft. lbs.)
Column Tube Set Nut 25 Nm (19 ft. lbs.)
Column Lower Tube Bracket Set Bolt 25 Nm (19 ft. lbs.)
Column Lower Tube Set Bolt 18 Nm (13 ft. lbs.)
Column Lower Tube Set Nut 21 Nm (15 ft. lbs.)
Intermediate Shaft To Sliding Yoke 35 Nm (26 ft. lbs.)
Sliding Yoke To Control Valve Shaft 35 Nm (26 ft. lbs.)
Steering Wheel Set Nut 35 Nm (26 ft. lbs.)
Steering Wheel Pad Set Screw 9 Nm (78 inch lbs.)