Crankshaft

SERVICE SPECIFICATIONS
Thrust Clearance
STD 0.020 - 0.220 mm (0.0008 - 0.0087 inch)
Maximum 0.30 mm (0.0118 inch)

Thrust Washer Thickness
STD 2.440 - 2.490 mm (0.0961 - 0.0980 inch)

Main Journal Oil Clearance
Standard:
No. 3 0.030 - 0.055 mm (0.0012 - 0.0022 inch)
U/S 0.25
No. 1, 2, 4, 5 0.025 - 0.065 mm (0.0010 - 0.0026 inch)
No. 3 0.030 - 0.070 mm (0.0012 - 0.0028 inch)
Maximum 0.10 mm (0.0039 inch)

Main Journal Diameter
Standard:
No. 1, 2, 4, 5 59.987 - 60.000 mm (2.3617 - 2.3622 inch)
No. 3 59.981 - 59.994 mm (2.3615 - 2.3620 inch)
U/S 0.25:
No. 1, 2. 4, 5 59.745 - 59.755 mm (2.3522 - 2.3526 inch)
No. 3 59.740 - 59.750 mm (2.3520 - 2.3524 inch)

Main Bearing Center Wall Thickness
Mark 1 1.987 - 1.990 mm (0.0782 - 0.0783 inch)
Mark 2 1.991 - 1.993 mm (0.0784 - 0.0785 inch)
Mark 3 1.994 - 1.996 mm (0.0785 - 0.0786 inch)
U/S 0.25 2.106 - 2.112 mm (0.0829 - 0.0831 inch)

Crank Pin Diameter
STD 52.987 - 53.000 mm (2.0861 - 2.0866 inch)
U/S 0.25 52.745 - 52.755 mm (2.0766 - 2.0770 inch)

Circle Runout
Maximum 0.03 mm (0.0012 inch)

Main Journal Taper And Out-Of-Round
Maximum 0.02 mm (0.0008 inch)

Crank Pin Taper And Out-of-round
Maximum 0.02 mm (0.0008 inch)

TIGHTENING SPECIFICATIONS
Drive Plate To Crankshaft 74 Nm (750 kg.cm, 54 ft. lbs.)