Input Signal Check

Input Signal Check

1. a. For check No.1 ~ No.2
Turn the ignition switch ON.

b. For check No.3 ~ No.7
(1) Turn the ignition switch ON.
(2) Shift to the D position.

c. For check No.8 ~ No.9
(1) Jack up the vehicle.
(2) Start the engine.
(3) Shift to the D position.

2. Press the control switch to SET/COAST or RES/ACC position and hold it down (1).
3. Push the main switch on (2).
4. Check that the CRUISE MAIN indicator light blinks twice or 3 times repeatedly after 3 seconds.
5. Turn the SET/COAST or RES/ACC switch off.
6. Operate each switch as listed in the table below.
7. Read the blinking pattern of the CRUISE MAIN indicator light.
8. After the check is done, turn the main switch off.

HINT:
- When 2 or more signals are input to the ECU, the lowest-numbered code is displayed first.
- If there in no indication code, perform troubleshooting and inspection.
- Indication is stopped when the MAIN switch is repushed.