Removal and Installation

Rear Brake Caliper Components:

REMOVAL
1. Disconnect flexible hose.
(a) Remove the union bolt and 2 gaskets from the Caliper, then disconnect the flexible hose from the Caliper.
Torque: 30 Nm (22 ft. lbs.)
(b) Use a container to catch the brake fluid as it drains out.
2. Remove Caliper.
Remove the 2 sliding pins and Caliper.
Torque: 88 Nm (65 ft. lbs.)
3. Remove these parts:
(a) 2 Brake Pads with anti-squeal shims.
(b) 4 pad support plates.

INSTALLATION
Installation is in the reverse order of removal, noting the following:
- bleed brake system. Service and Repair
- Check for leaks.