Power Window Circuit Breaker: Testing and Inspection

Power Window Control System:

INSPECT POWER WINDOW MOTOR CIRCUIT BREAKER OPERATION

Power Window Motor Circuit Breaker / Driver's Door:

Driver's Door:
1. Disconnect the connector from the master switch.
2. Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 6 on the wire harness side connector and raise the window to full closed position.
3. Continue to apply voltage, check that there is a circuit breaker operation noise within approximately 4 to 40 seconds.

Power Window Motor Circuit Breaker / Driver's Door:

4. Reverse the polarity, check that the window begins to descend within approximately 60 seconds.

If operation is not as specified, replace the motor.

Power Window Motor Circuit Breaker / Front Passenger's Door:

Front Passenger's Door:
1. Disconnect the connector from the power window switch.
2. Connect the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 1 on the wire harness side connector, and raise the window to full closed position.
3. Continue to apply voltage, check that there is a circuit breaker operation noise within approximately 4 to 40 seconds.

Power Window Motor Circuit Breaker / Front Passenger's Door:

4. Reverse the polarity, check that the window begins to descend within approximately 60 seconds.

If operation is not as specified, replace the motor.

Rear Left Side Door:
Refer to Front Passenger's Door.

Rear Right Side Door:
Refer to Front Passenger's Door.