Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION SENSOR REMOVAL AND INSTALLATION

REMOVAL

1. Remove engine under cover.
2. Remove generator.





3. Remove generator bracket.
Remove the 3 bolts and bracket.

Torque:
Bolt A: 74.5 N.m (760 kgf.cm, 55 ft.lbf)
Bolt B: 18 N.m (180 kgf.cm, 13ff.lbf)

4. Disconnect crankshaft position sensor connector.





5. Remove crankshaft position sensor.
(a) Remove the 2 bolts and crankshaft position sensor.

Torque: 8.5 N.m (85 kgf.cm, 74 in.lbf)

(b) Remove the O-ring.

INSTALLATION HINT:
- Always use a new O-ring when installing the crankshaft position sensor.
- Apply a light coat of engine oil on the O-ring.

INSTALLATION

INSTALLATION HINT: Installation is in the reverse order of removal.