P/S Pump Assembly Removal and Installation

P/S Pump Assembly

Removal





1. Remove the serpentine accessory drive belt.
2. Position a drain pan to catch the power steering fluid that will drain from the high-pressure hose after it is disconnected from the power steering pump.





3. Disconnect the high-pressure hose and the supply hose from the power steering pump.





4. Remove the bolt from the front right side of the power steering pump. Loosen the rear right bolt and swing the bracket out of the way.





5. Remove the two long power steering pump bolts and remove the power steering pump from the vehicle.

Installation
1. Install the power steering pump into the vehicle and install the two long power steering pump bolts.

Tighten: Tighten the power steering pump bolts to 25 Nm (18 ft. lbs.).





2. Swing the power steering pump bracket down and install the front right side bolt.

Tighten: Tighten both of the right side power steering pump bracket bolts to 35 Nm (26 ft. lbs.).
3. Connect the supply hose to the power steering pump.





4. Connect the high-pressure hose fitting to the power steering pump.
Tighten: Tighten the high-pressure hose fitting to 28 Nm (21 ft. lbs.).
5. Install the serpentine accessory drive belt.
6. Refill the power steering fluid.





7. Bleed the power steering system.