Brake Shoe: Testing and Inspection

Rear Brake Shoe On-Vehicle Check
Inspection should be carried out on the following points after brake pedal travel (pedal to silencer clearance) check as described on Excessive Pedal Travel Check, even when it is more than specification.

Amount of brake shoe wear can be checked as follows.

1. Hoist vehicle.
2. Remove rubber plug (1) from brake back plate.
3. Through hole of back plate, visually check for thickness of brake shoe lining (2). If lining thickness less than specified wear limit, replace with new brake shoes.
Lining thickness "a"
Service limit: 1.0 mm (0.04 in.)