Brake Pipe

Brake Pipe

REMOVAL

NOTE: Airbag system wiring harness is routed near the center brake pipe

CAUTION:
^ All airbag system wiring harness and connectors are colored yellow. Do not use electrical test equipment on these circuits.
^ Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
^ When removing the brake pipe, make sure that it is not bent.

INSTALLATION

NOTE: Airbag system wiring harness is routed near the center brake pipe

CAUTION:
^ All airbag system wiring harness and connectors are colored yellow. Do not use electrical test equipment on these circuits.
^ Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
^ When installing the brake pipe, make sure that it is not bent.
^ After installing the brake pipe and hose, bleed the air.
^ After installing the brake hose, make sure that it does not touch the tire or suspension assembly, etc.

Brake pipe tightening torque: 15 Nm (1.5 kgf-m, 10.8 ft. lbs.)

INSPECTION
Ensure there are no cracks, breakage, or damage on pipes Check the joints for fluid leakage If any cracks, breakage, damage or leakage is found, repair or replace the pipe.

NOTE: Use a mirror when inspecting low-visible part or back side