Brake Pressure Modulator Valve Bracket Replacement

Brake Pressure Modulator Valve Bracket Replacement (HP7)

Removal Procedure

1. Place the ignition switch in the OFF position.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




3. Remove the 2 brake pressure modulator valve (BPMV) bracket bolts (1).




4. Remove the BPMV bolt (1).




5. Without disconnecting the brake pipe fittings, carefully lift the BPMV assembly (1) upward to release the mounting pins from the BPMV bracket insulators.
Do not pry on the accumulator caps on the underside of the BPMV.
6. Position the BPMV assembly aside and secure with heavy mechanics wire or equivalent.
7. Inspect the insulators for damage and replace, if necessary.

Installation Procedure




1. Install the BPMV (1) to the bracket.





Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the BPMV bolt (1) and tighten to 10 Nm (89 lb in).




3. Install the 2 BPMV bracket bolts (1) and tighten to 10 Nm (89 lb in).
4. Lower the vehicle.