Replacement

Removal
1. Disconnect the battery cables and lift out the battery.
2. Undo the fuel filter and move it aside.
- (Not model year 1990 and later cars.)
3. Empty the brake fluid reservoir.
4. Disconnect the hoses from the master cylinder and bend them up out of the way beside the brake fluid reservoir.
5. Undo the pipe connections.
6. Unbolt the master cylinder from the brake servo unit.

Installation





1. Reinstall the master cylinder.
- Tighten the master cylinder's nuts securing it to the brake servo unit.
- Tighten to: 27 Nm (20 ft lb)
2. Reconnect the brake pipes and tighten the connections.
3. Reconnect the hoses from the brake fluid reservoir.
- Take care to ensure that the sealing rings are not pressed out of position.
4. Fill up with brake fluid, DOT 4 specification.
5. Bleed the brake system.
6. Reinstall the fuel filter.
- (Not model year 1990 and later cars.)
7. Put the, battery back in place and reconnect the cables.