Removal

1. Drain the refrigerant from the A/C system. For more information refer to "Draining and Filling of Refrigerant-R134a or R12". Service and Repair
2. Lift the servo oil container to one side.
3. Fit clamp 83 94 488 to the multi V belt.
4. Where appropriate, fit a protector over the oil cooler.





5. Unplug the compressor connector.
6. Remove the compressor retaining screws and place the compressor on the radiator crossmember, with a little paper underneath to protect against leaks.

CAUTION: Both the receiver dryer (desiccant container) and the compressor oil in the R134a system absorb water from the air, which cannot then be removed. For this reason, any connections which are open should be immediately plugged.

7. Detach the hose to the condenser using a holding tool. Plug openings.
8. Detach the pipe to the evaporator using a holding tool. Plug openings.
9. Unplug connector to pressure switch.
10. Remove the retaining screws and lift up the desiccant container.