Installing the Roll-Over Bar

Steps 1 - 5:

Steps 6 - 1-:

Procedures No. 1 - 5:

Procedures No. 6 - 10:

Danger:
Re-tighten with correct tightening torque!
- Carry out a test drive after performing assembly work on the roll-over bar/spring strut mount threaded parts on the body and then re-tighten the fastening nuts -7- with the correct tightening torque!


NOTE: Initially screw in and centre all the fastening screws and fastening nuts only in the sections -A, B, D, E- and in the base cage -C-. Only then tighten the threaded parts with the prescribed tightening torques. Adjust the adjusting element -2- last.