Disassembly

- Drive out input shaft seal in direction of bell housing with an appropriate mandrel.





- Drive roll pin out.

CAUTION: Mark throwout lever and shaft to ensure proper position when installing.





- Drive out lever shaft bushings with special tool P 375.
- Remove bushing.
- Using a small screwdriver, remove both snap rings from the housing for input shaft and pinion shaft bearings.

NOTE: The retaining rings are pressed against the housing by the bearing outer races. For this reason. first loosen the bearing racer from the snap rings with a punch.





- Heat housing to approximately 120°C (250 °F) on a hotplate and drive out both bearing outer races with special tool US 8050.
- Drive out shift rod needle bearing/bushing from inside of housing using an appropriate mandrel.