Transmission Housing

Disassembling
- Drive shift detent securing roll pins out.
- Drive half-round dowel pin out.

NOTE: Detent components are under spring tension. Therefore, always remove the roll pin first, then the half-round dowel pin.





- Heat gear housing to approximately 120°C (250 0F) and drive bearing outer races out using special tool US 8050.





Assembling
- Heat housing to approximately 120°C (250°F) and drive bearing outer races in with special tool US 8050.

CAUTION: The bearing outer races differ in inside diameter. The race with the larger inside diameter belongs to the pinion shaft (lower shaft).

- Install 5th and reverse speed shift rod.
- Insert long detent and drive roll pin in.





- Install spring and sleeve, tension both with special tool P 366, and drive roll pin in.
- Insert pin and detent (short), then drive the plug in. Reference next image for locations.





1 - Gear housing
2 - Half-round dowel pin
3 - 3rd and 4th speed selector fork(shift) rod
4 - Short detent
5 - Roll pin
6 - Pin
7 - Sleeve
8 - Spring
9 - Long detent
10 - Roll pin
11 - 5th and reverse speed selector fork (shift) rod