Front Suspension

Steering Knuckle Replacement

Removal Procedure

1. Raise and support the vehicle. refer to Vehicle Lifting.
2. Remove the bearing/hub assembly. Refer to Wheel Bearing/Hub Replacement - Front.
3. Disconnect the front lower control arm ball stud.
4. Disconnect the outer tie rod end from the steering knuckle.




5. Scribe the strut to the knuckle.




6. Remove the bolts and nuts attaching the strut to the knuckle.
7. Remove the knuckle from the vehicle.

Installation Procedure

1. Install the knuckle to the vehicle.





Notice: Refer to Fastener Notice in Service Precautions.

2. Install the through bolts and nuts attaching the strut to the knuckle.

Tighten the through bolts and nuts to 120 N.m (89 lb ft).

3. Connect the outer tie rod to the steering knuckle.
4. Connect the front lower control arm ball stud to the knuckle.
5. Install the front wheel drive shaft bearing. Refer to Wheel Bearing/Hub Replacement - Front.
6. Lower the vehicle.
7. Inspect the front wheel alignment and adjust if necessary. Refer to Measuring Wheel Alignment.