Accelerator Controls Cable Replacement (Cruise Actuator to Throttle)

ACCELERATOR CONTROLS CABLE REPLACEMENT (CRUISE ACTUATOR TO THROTTLE)

REMOVAL PROCEDURE




1. Loosen the cable adjusting locknuts (1).
2. Remove the accelerator throttle cable from the bracket.
3. Disconnect the accelerator cable from the throttle lever (3).Opening the throttle lever by hand will aide in the accelerator cable removal.




4. Remove the cruise control actuator cover (1) by applying a slight outward pressure to both sides at the base of the cover.




5. Remove the cable attaching screw (5).
6. Remove the accelerator throttle cable (4) from the bracket.
7. Disconnect the accelerator throttle cable (4) from the actuator lever (1).
8. Remove the accelerator throttle cable from the cable guide clip.

INSTALLATION PROCEDURE




1. Connect the accelerator throttle cable (4) to the actuator lever (1).
2. Install the accelerator throttle cable (4) into the bracket.
3. Secure with one screw.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the cable screw (5) to 2 N.m (18 lb in).





4. Install the cruise control actuator cover (1) by applying slight downward pressure to the cover.




5. Connect the accelerator throttle cable (2) to the throttle lever (3). Opening the throttle lever by hand will aide in the accelerator throttle cable installation.
6. Connect the accelerator throttle cable to the accelerator cable bracket.
7. Connect the accelerator throttle cable to the cable guide clip.
8. Adjust the cable adjusting locknuts to allow slight freedom of movement between the accelerator cable and the throttle lever.
9. Secure with the 2 nuts (1).

Tighten the adjusting locknuts to 8 N.m (71 lb in).