Accelerator Controls Cable Replacement (Cruise Actuator to Pedal)

ACCELERATOR CONTROLS CABLE REPLACEMENT (CRUISE ACTUATOR TO PEDAL)

REMOVAL PROCEDURE




1. Remove the cruise control actuator cover (1) by applying a slight outward pressure to both sides at the base of the cover.




2. Loosen the cable adjusting lock nuts (2).
3. Remove the accelerator pedal cable from the bracket.
4. Disconnect the accelerator pedal cable from the actuator lever (1). Rotating the actuator lever by hand will aide in the accelerator pedal cable removal.
5. Remove the accelerator pedal cable from the cable guide clip.




6. Disconnect the accelerator cable from the accelerator pedal.
7. Disconnect the 2 bolts (2) and the accelerator cable (5) and the bracket (1) at the bulkhead.
8. Remove the accelerator cable (5) from the vehicle.

INSTALLATION PROCEDURE




1. Install the accelerator pedal cable (5) and the bracket (1) to bulkhead.
2. Secure with the 2 bolts (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolts to 15 N.m (11 lb ft).

3. Connect the accelerator pedal cable to the accelerator pedal.




4. Connect the accelerator pedal cable (3) to the actuator lever (1). Rotating the actuator lever (1) by hand will aide in accelerator pedal cable installation.
5. Connect the accelerator pedal cable to the cable guide clip.
6. Install the accelerator pedal cable (3) into the bracket.
7. Adjust the cable adjusting locknuts to allow slight freedom of movement between the accelerator pedal cable and the actuator lever.
8. Secure the cable adjustment with the 2 cable adjusting locknuts (2).

Tighten the locknuts to 8 N.m (71 lb in).