Canister Purge Solenoid: Service and Repair

EVAPORATIVE EMISSION (EVAP) CANISTER PURGE SOLENOID VALVE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the fuel injector sight shield.

IMPORTANT: The evaporative emission (EVAP) purge valve is located on the upper intake manifold.

2. Disconnect the EVAP canister purge valve purge pipe (2).
3. Disconnect the EVAP canister purge valve electrical connector.




4. Remove the EVAP purge valve bolt (2).
5. Remove the EVAP purge valve (3).

INSTALLATION PROCEDURE




1. Install the EVAP purge valve (3).
2. Install the EVAP purge valve bolt (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 12 N.m (106 lb in)

3. Connect the EVAP canister purge valve electrical connector.




4. Connect the EVAP canister purge valve purge pipe (2).
5. Install the fuel injector sight shield.