Brake Pressure Modulator Valve (BPMV) Bracket Replacement

Brake Pressure Modulator Valve (BPMV) Bracket Replacement

Removal Procedure





1. Turn the ignition switch to the OFF position.
2. Remove the EBCM/BPMV assembly to mounting bracket bolt.
3. Without disconnecting any brake pipes, remove the EBCM/BPMV assembly from mounting bracket, then carefully reposition and support the modulator assembly to provide access for bracket removal.





4. Remove the master cylinder mounting nuts.
5. Remove the BPMV bracket from the vehicle.

Installation Procedure





1. Install the BPMV bracket into position in the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the master cylinder mounting nuts.
^ Tighten the nuts to 27 Nm (20 ft. lbs.).





3. Install the EBCM/BPMV assembly to the mounting bracket.
4. Install the EBCM/BPMV assembly to mounting bracket bolt.
^ Tighten the bolt to 10 Nm (89 inch lbs.).