Standard

1. Raise and support vehicle.
2. Remove wheel and tire assembly.
3. Remove hold-down spring from caliper assembly by pressing spring outward.
4. Loosen, but do not remove caliper guide pins, then remove caliper from disc. Inboard pad will remain inside caliper. Support caliper assembly to prevent damage to hydraulic brake hose. Remove caliper guide pins only if bushings or sleeves are to be replaced.
5. Remove inboard pad from caliper and outboard pad from adapter.
6. Push caliper piston into bore. Remove some brake fluid from master cylinder reservoir to prevent overflowing when piston is pushed into bore.
7. Install new inboard pad into caliper with retainer positioned in piston bore.
8. Install outboard pad onto adapter.
9. Position caliper over brake disc and adapter, then torque guide pins to 18-26 ft. lbs.
10. Install hold-down spring, then install tire and wheel assembly and lower vehicle.
11. Check master cylinder reservoir for proper brake fluid lever.