Fog/Driving Lamp Switch: Service and Repair

FOG LAMP SWITCH REPLACEMENT - FRONT

REMOVAL PROCEDURE




1. Place the ignition switch in the OFF position.
2. Use a small flat-bladed tool to remove the outer air outlet from the instrument panel (IP).
3. Disconnect the electrical connectors (1) from the switches.




4. Remove the fog lamp switch (1) by disengaging the retainers.

INSTALLATION PROCEDURE




1. Install the fog lamp switch (1) to the IP outer air outlet. Press the switch into place until fully seated.




2. Connect the electrical connectors (1) to the switches.
3. Install the IP outer air outlet. Press the outlet into place until fully seated.