Power Steering Pressure Hose Replacement
Power Steering Pressure Hose ReplacementRemoval Procedure
1. Remove the drive belt from the vehicle.
2. Remove the power steering hose retaining nut (1) from the retaining bracket (2).
3. Remove the pressure hose (4) from the power steering pump (1).
4. Raise the vehicle on a hoist. Refer to Vehicle Lifting.
5. Remove the pressure hose (4) from the retaining bracket (6).
6. Remove the pressure hose (4) from the power steering gear (5).
7. Remove the pressure hose (4) from the vehicle.
Installation Procedure
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the pressure hose (4) to the power steering gear (5).
^ Tighten the pressure hose to 27 Nm (20 ft. lbs.).
2. Install the pressure hose (4) to retainer (6).
3. Lower the vehicle.
4. Install the pressure hose (4) to the power steering pump (1).
^ Tighten the pressure hose to 27 Nm (20 ft. lbs.).
5. Install the power steering hose retaining bracket (2) and the retaining nut (1).
^ Tighten the retainer nut (1) to 5 Nm (45 inch lbs.).
6. Ensure the power steering hose has sufficient clearance from the exhaust manifold.
7. Install the drive belt to the power steering pump pulley.
8. Bleed the air from the power steering system.