Dimmer Switch: Service and Repair

IP DIMMER SWITCH REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the fog lamp/dimmer switch/vent trim plate from the instrument panel using a small flat-bladed tool.
3. Disconnect the electrical connectors from the fog lamp/dimmer switches.
4. Remove the dimmer switch from the trim plate using a small flat-bladed tool on the back side to release the retainer tabs.

INSTALLATION PROCEDURE




1. Install the dimmer switch to the trim plate pressing into place until fully seated.
2. Connect the electrical connectors to the fog lamp/dimmer switches.
3. Install the fog lamp/dimmer switch/vent trim plate to the instrument panel pressing into place until fully seated.
4. Connect the negative battery cable.