Front Seat Adjuster Replacement (Six-Way Power)

Front Seat Adjuster Replacement (Six-Way Power)

Removal Procedure

1. Remove the front seat. Refer to Seat Replacement - Front Bucket.
2. Place the front seat upside down on a clean, protected surface.
3. Note the location of the power seat adjuster electrical wiring harness.
4. Disconnect and remove the electrical wiring harness from the adjuster assembly.
5. Remove the trim finish panels. Refer to Seat Cushion Outer Trim Panel Replacement (Seat Cushion Outer Trim Panel Replacement).




6. Remove the seat adjuster to cushion frame bolts.
7. Remove the seat adjuster from the seat cushion frame.
8. Remove the drive cables. Refer to Seat Horizontal and Vertical Drive Cable Replacement (Seat Horizontal and Vertical Drive Cable Replacement).
9. Remove the cross-brace bolts.
10. Remove the cross-brace and separate the adjusters.

Installation Procedure





Important: Make sure both power seat adjusters are in phase with each other before attaching the cross-brace.


1. Attach the cross-brace to the power seat adjusters.
Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the cross-brace bolts.

Tighten the cross-brace bolts to 6 Nm (53 lb in).

3. Install the drive cables. Refer to Seat Horizontal and Vertical Drive Cable Replacement (Seat Horizontal and Vertical Drive Cable Replacement).
4. Install the seat adjuster to the seat cushion frame.
5. Install the seat adjuster to the cushion frame bolts.

Tighten the seat adjuster to cushion frame bolts to 24 Nm (18 lb ft).

6. Install the trim finish panels. Refer to Seat Cushion Outer Trim Panel Replacement (Seat Cushion Outer Trim Panel Replacement).
7. Install and connect the electrical wiring harness to the adjuster assembly.
8. Install the front seat. Refer to Seat Replacement - Front Bucket.