Front

Disassembly Procedure





1. Remove the front brake caliper. Refer to Brake Caliper Replacement - Front.

Caution: Do not place your fingers in front of the piston in order to catch or protect the piston while applying compressed air. This could result in serious injury.

Notice: Use clean cloths to pad interior of caliper housing during piston removal. Use just enough air to ease the pistons out of the bores. If the pistons are blown out, even with the padding provided, it may be damaged.

2. Remove the piston. Blow compressed air into the caliper inlet hole (2). The piston will come out through the piston boot.
3. Inspect the piston for the following conditions:
^ Scoring
^ Gouges
^ Corrosion
^ Worn or damaged surface
Replace the piston if any of the above conditions are found.





4. Remove the caliper boot (2). Do not scratch the housing bore.

Notice: Do not use a metal tool for seal removal. Damage to the caliper bore or the seal grooves can result.





5. Remove the piston seal (4) from the groove in the caliper bore (3). Use a small wooden or plastic tool.
6. inspect the caliper bore (3) and the seal grooves (4) for the following conditions:
^ Scoring
^ Nicks
^ Corrosion
^ Wear
7. Use a crocus cloth in order to polish out light corrosion.
8. Replace the caliper housing (3) if corrosion in and around the deal groove cannot be cleaned with a crocus cloth.
9. Inspect the seal groove in the caliper bore for nicks or burrs. Replace the caliper if the seal groove is damaged.
10. Remove the bleeder valve cap (1) and the bleeder valve (2) from the caliper housing (3).
11. Clean all the parts in denatured alcohol.
12. Dry all the parts with filtered, non-lubricated compressed air.
13. Blow out all the passages in the caliper housing and the bleeder valve. Use filtered, non-lubricated compressed air.

Assembly Procedure
^ Tools Required
- J 36349 Front Dust Boot Seal Installer

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the bleeder valve and the bleeder valve cap to the caliper housing.
^ Tighten the bleeder valve to 13 Nm (115 lb in).
2. Lubricate the new piston seal with clean brake fluid.
3. Install the piston seal into the caliper bore grooves. Verify that the piston seal is not twisted.





4. Lubricate the piston boot (1) with clean brake fluid.
5. Install the lubricated boot (1) onto the piston (2).
6. Lubricate the piston OD with clean brake fluid.





7. Install the piston and the boot into the bore of the caliper. Push the piston to the bottom of the bore.
8. Seat the caliper boot in the caliper housing (1) counterbore using J36349.
9. Install the front brake caliper. Refer to Brake Caliper Replacement- Front.