Circuit Description

The Crankshaft Position (CKP) sensor (2) used on this engine is actually two sensors within a single housing. Each sensor has a separate power, ground and signal circuit. The PCM supplies 12 Volts to both sensors. The PCM provides the ground path, or sensor return circuit, from both sensors. These power and ground circuits are also connected to the CMP sensor. Two separate signal circuits connect the CKP sensor and the PCM.

The PCM can use three different modes of decoding crankshaft position. During normal operation, the PCM performs an Angle Based calculation using both signals to determine crankshaft position. The dual sensor allows the engine to run even if one signal is lost. If either signal is lost, the PCM switches to a Time Based method of calculating crankshaft position. If the system is operating in Time A mode, the PCM is using only the signal from Sensor A. Time B indicates that the Sensor B signal is being used. If the lost signal is restored, the PCM will continue to operate in Time based mode for the remainder of the current key cycle. The PCM will revert back to the Angle mode on the next start if the fault is no longer present. The scan tool can display the Crank Position Sensing Decode Mode. A problem with sensor A will set DTC P0335. A problem with sensor B will set P0385.